loading
reading
writing
saving
searching
ARM SBC NAS KIT - $200
QR Code Link to This Post
PCIe to 6x Sata Card (60 new)
PicoPSU (100 new)
Fan Controller board with thermal probe (so fan can be quiet when drives spin down) (10 new)
PSU breakout board with fuses and on/off switch (to power the fan controller board (20 new)
BeQuiet Fan (20 new)
Case for drives (20 new)
Plexiglass (non-conductive to set the boards on) (10 new)
All of it works, I just replaced the setup with a N3 mITX x64 build. Selling to offset the cost of that. Good for tinkerers. ARM is low power, the PCIe Sata card also allows you to directly connect to the drives over sata and spin them down to idle, which makes the whole setup ultra low power. Fan also varies speed based on thermal load from the drives, so it's very quiet when everything is idle. Comes with a picopsu to power the drives